Smoke seal installation for fire-rated doors

Smoke seal installation for fire-rated doors is a crucial step in ensuring the safety of a building and its occupants. Fire-rated doors are designed to prevent the spread of fire and smoke in the event of a fire, but without proper smoke seals, they may not be as effective as intended.

Smoke seals are strips of intumescent material that are installed around the edges of fire-rated doors to create a tight seal when the door is closed. This seal helps prevent smoke from seeping through gaps around the door, reducing the risk of smoke inhalation and allowing occupants more time to evacuate safely in case of a fire.

Installing Smoke seal installation for fire-rated doors is relatively simple and can be done by following a few basic steps. The first step is to measure the length of each side of the door frame where the smoke seal will be installed. Once you have these measurements, you can cut the smoke seal strips to size using a utility knife or scissors.

Next, clean and dry the surfaces where you will be installing the smoke seals to ensure that they adhere properly. Then, peel off the backing from one side of the smoke seal strip and press it firmly onto one edge of the door frame. Repeat this process for each side of the door frame until all edges are sealed with smoke seals.

After installing all four sides of the door frame with smoke seals, make sure that they form a continuous seal when you close the door. You may need to adjust or trim any excess material to ensure that there are no gaps where smoke could escape.

In addition to installing smoke seals on fire-rated doors, it is also important to regularly inspect and maintain them to ensure their effectiveness. Over time, wear and tear or damage can compromise their ability to create an effective seal against smoke infiltration during a fire.

By taking these steps to install and maintain smoke seals on fire-rated doors, building owners can help protect their property and occupants in case of a fire emergency. It is important not only for compliance with building codes but also for peace-of-mind knowing that every precaution has been taken to ensure safety in potentially life-threatening situations.

In conclusion, installing smoke seals on fire-rated doors is an essential part of maintaining building safety standards.

A-24 Hour Door National
6835 Greenway Ave, Philadelphia, PA 19142
(215) 654-9550

By admin

Leave a Reply

Your email address will not be published. Required fields are marked *